Ramset 50-777INT - Intelligate Control Board Reviews
Other Picture
Ramset 50-777INT - Intelligate Control Board Feature
- Works with all of Ramset's slide, swing and overhead vehicular gate operators
- Eliminating messy wire connections
- Automatically closes the gate after 0 - 60 seconds after the gate fully opens
- Adds a 3 second delay before the gate moves in any direction
- Allows an alarm or light to be connected to show when the gate is moving
Ramset's "Intelligate" control board works with all of Ramset's slide, swing and overhead vehicular gate operators. The "Intelligate" features: Plug-in loop detectors: Allows ILD-24 plug-in loop detectors (sold separately) to be used, eliminating messy wire connections. This allows no necessary board modifications between 110-Volts AC and 220-Volts AC single-phase applications. The "Intelligates" functions include: Automatic close timer: Automatically closes the gate after 0 - 60 seconds after the gate fully opens and all of the safety devices are cleared. Pre warning: Adds a 3 second delay before the gate moves in any direction. During this 3 second delay the Pre-warn relay maintains a closed contact. This allows an alarm or light to be connected to warn when the gate is about to move. Constant warning: Triggers the Pre-warn relay to maintain a closed contact while gate is in motions. This allows an alarm or light to be connected to show when the gate is moving. Secure close: When power is lost, then regained, the control board checks the status of the gate. If the gate is open and the safety devices are cleared, the gate will automatically close. Radio cycle: Allows the gate to be stopped at any time with the remote control. Then reverse with another command. One pass: Closes the gate immediately after the safety devices are cleared. If another car triggers a safety device the gate will stop but not open until a valid open signal is received. Open and close delay: Adds a 1 second delay before the gate opens and / or closes. Left or Right: With a flip of a switch, the logic of the control board changes from a left hand operation to a right hand operation. Master/Slave: Synchronizes two gates to work together in a bi-parting installation. ERD (Electronic Reversing Devices): Automatically adjusts the sensitivity of the operator to the size of the gate.
Visit Store Now !!
Aug 29, 2011 16:14:19
0 comments:
Post a Comment